SR-1000HD (pas premium)

[toonsi]

Bonjour Digital, si tu ne peux pas le faire reparer et que tu n'as plus d'autres choix tu peux essayer un dernier moyen avec les risques que cela comporte: la methode HyperTerminal.
Ce programme est présent dans windows jusqu'à XP, ensuite il faut le telecharger gratuitement sur le net ou bien là:

**Contenu caché: Cliquez sur Thanks pour afficher. **

Suis les 2 methodes suivantes:

Methode A
1_ Open Hbertrnimal program of
2_ filling machine from fallow back Receiver
3_ press at the same time on the three buttons of the keyboard
Ruler & Shift & 2 at the same time with continued pressure and lift
As the picture below
Until a message appears
STB225 v1 nand
http://www5.0zz0.com/2011/12/24/11/835072982.png
When the message appears as image advancing green
We write the following command
run menu
Then we press Inter keyboard

http://www12.0zz0.com/2011/12/24/11/898044890.png

After pressing the Inter from the keyboard
http://www11.0zz0.com/2011/12/24/11/967281870.png

After pressing the Inter message appears above
Please insert order
No. 4, and then writes Inter
http://www4.0zz0.com/2011/12/24/11/676260012.png
After writing No. 4 and the pressure on Inter begin the process of organizing sizes and arrangement of the parts

http://www13.0zz0.com/2011/12/24/11/152493994.png

Now at this stage Put your device version put flashdisk
And put the receiver and then restart the receiver from the back and leave fallow receiver the usual update process will return to work

Methode B
Instructions for the emergency: uboot new flashing alien1

Instructions for the emergency: uboot new flashing


There are increasing reports of users that shooting up the boot loader or corrupt, although this should be impossible due to read-only
The box gets stuck in the episode at boot time (display: boot) no longer boots up, no matter if spark or Enigma.

Normally, this is a case of warranty.
You can save postage and time but by you yourself new overrides in case of emergency the submarine.

Attention: only for users with some clue in matter > everyone else please the box send to repair!

Instructions:
What is needed?
Null modem cable
Hyper terminal program (Windows XP: start > Accessories > communications > HyperTerminal)
Note: starting with Windows Vista, HT is no longer part of Windows, but there are freeware.

Emergency-HowTo: override bootloader
==================================

Use only in case of an emergency!

-Switch off box, then connect to PC/laptop via null-modem cable (RS232)
-Start HyperTerminal and create new connection
-> select correct COM interface
-> Bits per second: 115-200
-> Flow control: no

-Then transfer > Send file
-Select correct uboot-xxx.bin
-Log: Ymodem
-Click send!

> now before turning on the box!
-When you turn hold button [OK] to [FORC] appears
-then left arrow [<] press
-RS232 appears on the display

Now is the transmission, which should take about 2 minutes.
Turn off not prematurely or other maneuvers at this stage!

Flash at your own risk!

Thx ans RSP-Team für den uboot-alien und an Dirk Tössfeld für den uboot-pingulux.


Code:

**Contenu caché: Cliquez sur Thanks pour afficher. **

BON COURAGE!