ilcorsarorosso
05/01/2017, 08h56
ADD Patch disablecrccws per Caid thanks to yoyodebug
example: for Csat
Add this Line for ncam.server
disablecrccws_only_for = 0500:032830
ncam.server
[reader]
label = server1
enable = 1
protocol = cccam
device = host,port
user = user
password = password
group = 1
cccversion = 2.0.11
disablecrccws_only_for = 0500:032830
cccmaxhops = 2
ccckeepalive = 1
audisabled = 1
[gbx]
fix for local card change (card detected/ ejected) not reported to peers
Change two defaults to more reasonable values
-Webif
-Correct cooldown parameter in webif
-Improve the Webif configuration screen.
-Add httpreadonly as a parameter in the webif
-Make all config parameters for the webif clickable to point to the Wiki
-Small reorganization of the parameters that display additional infos in the Status screen to place then in the same order as they are displayed when we enable them.
[gbx]
add feature
block ecm from specific peer(s)
ignore specific peer(s) entirely
fix Warning ref. cs_readlock timeout
code clean up and cosmetics
[DOC]
add optional parameter to Ncam.conf [gbox]:
block_ecm = peer_id[,peer_id...]
ignore_peer = peer_id[,peer_id...]
build-mips ( gigablue,dream,vu+,xtrend,formuler )
**Hidden Content: Check the thread to see hidden data.**
build-sh4 ( Golden Media-Galaxy Innovations-Amiko )
**Hidden Content: Check the thread to see hidden data.**
example: for Csat
Add this Line for ncam.server
disablecrccws_only_for = 0500:032830
ncam.server
[reader]
label = server1
enable = 1
protocol = cccam
device = host,port
user = user
password = password
group = 1
cccversion = 2.0.11
disablecrccws_only_for = 0500:032830
cccmaxhops = 2
ccckeepalive = 1
audisabled = 1
[gbx]
fix for local card change (card detected/ ejected) not reported to peers
Change two defaults to more reasonable values
-Webif
-Correct cooldown parameter in webif
-Improve the Webif configuration screen.
-Add httpreadonly as a parameter in the webif
-Make all config parameters for the webif clickable to point to the Wiki
-Small reorganization of the parameters that display additional infos in the Status screen to place then in the same order as they are displayed when we enable them.
[gbx]
add feature
block ecm from specific peer(s)
ignore specific peer(s) entirely
fix Warning ref. cs_readlock timeout
code clean up and cosmetics
[DOC]
add optional parameter to Ncam.conf [gbox]:
block_ecm = peer_id[,peer_id...]
ignore_peer = peer_id[,peer_id...]
build-mips ( gigablue,dream,vu+,xtrend,formuler )
**Hidden Content: Check the thread to see hidden data.**
build-sh4 ( Golden Media-Galaxy Innovations-Amiko )
**Hidden Content: Check the thread to see hidden data.**